It is currently Mon Jun 17, 2019 8:51 am

Reply to topic  [ 2 posts ] 
How to reset start of sequence 
Author Message

Joined: Fri May 30, 2008 2:08 pm
Posts: 1
Post How to reset start of sequence
I have search a sequence for open reading frames. MacVector shows one that starts at nucleotide #1 but that is not an ATG start site, even though it is suppose to find ORFS whose 5' end is a start codon. How can I reset the sequence numbering so that the #1 nucleotide is a different nucleotide in the sequence? In other words, how can I reset the start of the sequence, to any nucleotide within the sequence?


Mon Apr 06, 2009 10:17 am
Profile WWW
Site Admin
User avatar

Joined: Thu Dec 07, 2006 5:56 pm
Posts: 113
Post Re: How to reset start of sequence
(Very delayed reply!)

In the Editor tab, just drag the red cross seen at the beginning of the sequence to where you want the numbering to start. After doing this all sequence before this red cross is numbered negatively.

Fri Apr 16, 2010 8:42 am
Profile WWW
Display posts from previous:  Sort by  
Reply to topic   [ 2 posts ] 

Who is online

Users browsing this forum: No registered users and 3 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group.
Designed by ST Software for PTF.